Fortinet FortiGate-5000 Manual de usuario descargar pdf (Pagina 75)

FortiController-5208 system Front panel LEDs and connectors

FortiGate-5000 Series Introduction

01-30000-83466-20090108 75

The control LEDs of a secondary FortiController-5208 board will be synchronized

to the control LEDs of the primary because all the installed boards use the same

fabric backplane network to communicate. Each FortiController-5208 board has

its own base backplane network with which to exchange data traffic with the

worker boards so the data LEDs of each FortiController-5208 board will indicate

only its own communication.

Connectors

Tab l e 2 6 lists and describes the FortiController-5208 board connectors.

CONTROL 1-16 Green The control LEDs display the fabric backplane

connections of the FortiController-5208 board,

an optional secondary FortiController-5208 board,

and all the 5005 boards, over which management

communication is sent. LED 1 is for the

FortiController-5208 board’s connection. LEDs 2

through 14 are for connections to the corresponding

slots in a 5050 or 5140. LEDs 15 and 16 are for

future use.

Flashing Management communication activity on the fabric

backplane connection.

1, 2, 3, 4 Green The correct cable is connected to the gigabit SFP

interface.

Flashing Network activity at the gigabit SFP interface.

IPM Blue The FortiController-5208 is ready to be hot-

swapped (removed from the chassis). If the IPM

light is blue and no other LEDs are lit the

FortiController-5208 board has lost power. See

“Inserting a FortiController-5208 module into a

chassis” on page 10 for more information.

Flashing

Blue

The FortiController-5208 is changing from hot swap

to running mode or from running mode to hot swap.

Off Normal operation. The FortiController-5208 board is

in contact with the chassis backplane.

MANAGEMENT Link

LED

Amber The correct cable is inserted into this interface and

the connected equipment has power.

Flashing Network activity at this interface.

Speed

LED

Green The interface is connected at 1000 Mbps.

Amber The interface is connected at 100 Mbps.

Unlit The interface is connected at 10 Mbps.

Table 25: FortiController-5208 board LEDs (Continued)

LED State Description

Table 26: FortiController-5208 connectors

Connector Type Speed Protocol Description

X1, X2 XFP 10 Gbps Ethernet Two 10 gigabit XFP interfaces that

can accept fiber or copper

transceivers. These interfaces

operate only at 10 Gbps. See

“Installing XFP and SFP transceivers”

on page 9 for more information.

1 2 ... 70 71 72 73 74 75 76 77

Comentarios a estos manuales

Sin comentarios

Fortinet FortiGate-5000 Manual de usuario Pagina 75

Comentarios a estos manuales

Relacionado con productos y manuales para Módulos transceptores de red Fortinet FortiGate-5000